Qingdao Terada Hardware Co.,Ltd
(1) stainless steel wire rope The size of the clips should be suitable for the thickness of the wire rope. The inner clearance of the U-ring should be 1 ~ 3mm larger than the diameter of the wire rope.
(2) When using the stainless dog clips, tighten the U-bolt until the rope is flattened by about 1/3. As the wire rope in the deformation after the force, the rope in the rope after the second tightening force to ensure the solid connector. If you want to check the rope after the force, whether the rope slip, can take additional stainnless steel cable clips to carry out. heavy duty wire rope clips installed in the last rope from about 500mm, the rope will be released after a safe bend and the main rope clamp, so that if the clip has a sliding phenomenon, the safety bend will be straightened, easy to find and Reinforcement in time.
(3) wire rope clips spacing between the general wire rope diameter of about 6 to 7 times, clips should be aligned, the U-ring part should be stuck in the rope side, the pressure plate on the side of the main rope.
(4) the correct number and method of arrangement: the diameter of the wire rope is less than or equal to 18mm, a minimum of 3; wire rope diameter 18mm ~ 26mm, at least 4; wire rope diameter 26mm ~ 36mm, at least 5; wire rope diameter 36mm ~ 44mm, ; Wire rope diameter 44mm ~ 60mm, at least 7; cable clips installed by the load one or two should be checked whether the loose. Under normal circumstances, the nut needs to be tightened further. stainless steel wire rope clips Note: Do not use for a long time, should be regularly checked, regularly scrapped, can not be used repeatedly
Copyright © Qingdao Terada Hardware Co.,Ltd All Rights Reserved.