Qingdao Terada Hardware Co.,Ltd
1) The size of the wire rope clamp should be suitable for the thickness of the wire rope. The inner clearance of the U-shaped ring should be 1 ~ 3mm larger than the wire rope diameter.
(2) When using, it is necessary to tighten the U-shaped bolts until the wire rope is crushed 1/3 or so far. As the wire rope in the deformation after the force, the rope in the rope after the second tightening force to ensure the solid connector. If you want to check the rope in the force, the rope is sliding, can take an additional safety rope card to carry out. Safety rope installed in the last rope from about 500mm, the rope will be released after a safe bend and the main rope clamp, so that if there is a sliding clamp phenomenon, the safety will be straightened straight for easy to find and timely reinforcement .
(3) The spacing between the rope card is generally about 6 to 7 times the diameter of the rope, the rope card should be aligned, the U-ring part should be stuck in the rope side, the pressure plate on the side of the main rope.
(4) the correct number and method of layout:
The number of rope clamp is generally not less than 3-5, rope spacing should be ≥ 6 times the rope, the last clip from the rope pitch ≥ 140mm The number of clips according to the wire rope diameter,
≤ 19mm set 3,
19-32mm set 4,
32-38mm set 5,
38-44mm set 6,
44-60mm set of seven.
(5) rope rope clamp should be supporting the use of rope diameter less than 19mm, rope clamp should be not less than 3, 19-32mm should not be less than 4. Rope arrangement between the rope spacing is generally about 6 to 8 times the diameter of the rope, ropes to be aligned, the U-ring part should be stuck in the rope side, the pressure plate on the side of the main rope.After the rope clamp installed by the first and second should be checked whether the loose. Under normal circumstances, the nut needs to be tightened further.
Copyright © Qingdao Terada Hardware Co.,Ltd All Rights Reserved.